FapsCommunity
Carlos Eduardo from patreon
Carlos Eduardo patreon

🌟 Embark on a Duel: Our November 17th Launch! πŸš€

🕑 Added 2023-11-15 15:07:54 +0000 UTC
🌟 Embark on a Duel: Our November 17th Launch!  πŸš€
🌟 Embark on a Duel: Our November 17th Launch!  πŸš€
🌟 Embark on a Duel: Our November 17th Launch!  πŸš€
🌟 Embark on a Duel: Our November 17th Launch!  πŸš€
🌟 Embark on a Duel: Our November 17th Launch!  πŸš€
🌟 Embark on a Duel: Our November 17th Launch!  πŸš€
🌟 Embark on a Duel: Our November 17th Launch!  πŸš€
🌟 Embark on a Duel: Our November 17th Launch!  πŸš€

Comments

Richard Oliver

I personally love smaller parts to be able to scale into larger prints.

Eduardo Ferre

It would be interesting to leave a complete base uncut, there is a lot of small print and covering the lines with so much detail is very complicated, apart from also separating the center to put an LED inside

Eduardo Ferre

Yes, you are right, that option would be very good, also leaving a complete base without cutting

Richard Oliver

It would be great if the center section (not the whole base) that Yugi is standing on would be a seperate piece so we can print with clear resin and put LED's in to light the model similar to the pictures.


More Creators