tankbrusher
patreon
April Showcase: Hammerit, the tool for assembling tracks quickly!
🕑 Added 2023-04-01 16:54:04 +0000 UTCSick of dialing in your exposure settings?
Pins won't fully seat no matter what you try?
Got the dexterity to compensate your short fuse?
I got something for you!
I’m very proud to present Hammerit – the worlds first tool allowing rapid assembly of a full track run without having to deal with exposure calibration or special resins.
No cost was evaded to develop the future of resin pin, single link, tracks for 1/35th scale and below:
Hammerit does fit all standard pattern small hammers, larger ones will fit too. (Just give them a lick with a wire brush…)
How does it work?
1st The specially formed cone does allow you to pick up your resin pin right from the print bed.
2nd make sure you firmly secure the hinge of your track links with two fingers.
3rd with the pin firmly attached to the Hammerit extension, eyeball for the pin hole and give it a firm swing.
4th be done with your scale modelling session in no time!
STLs available to Patreon only on 1st of April ; )
Test it now, thank me later ; )
Comments
Todd Ponto
Oh well I guess April Fools on me
It's an April's fool joke. I won't release something you'd most certainly hurt yourself with ; )
Todd Ponto
I dont see the stl for this in the releases I have gotten from Dec to now. Which month is this hammer in
