MINJAK // Jakob
patreon
Jin Dahaad Instructions
🕑 Added 2025-06-21 05:21:11 +0000 UTCUpdated for 2025 Rebrand.
Please check the pinned post for guides on acquiring the pieces needed for these builds via Bricklink!
If you experience any errors, the troubleshooting guide is also linked there!
Thanks for the support, here is the mighty Jin Dahaad in all his frozen glory!
This model is huge, and while the model can stand just fine without any display stand, it looks for more impressive (and is much more secure) when displayed with the optional Iceshard Cliffs display stand build, also included. The Display Stand is also included in the Monster Display Stands post as well.
STAND GUIDE:
It's pretty self explanatory, the 4 feet are connected to the technic pins found on the 4 floating rocks. The tail is attached via the small technic connector on the back pillar. The small connector may have to be repositioned depending on tail's pose.
Remember to REMOVE the small additional transparent prop for the tail and the orange rubber pieces on the bottom of the feet.
You could theoretically add more monsters to the display stand, such as Hirabami, with extra pieces and tinkering.
PLEASE NOTE: the models in the example image (my personal model) is a prototype and not representative of the final model you will build via the instructions!
As always, please refer to the video guide pinned at the top of my Patreon page for assistance on acquiring the pieces!
Comments
Curtis harper
Are the stand pieces included in the rar link for Jin?
MINJAK // Jakob
Oh right, yes just remove the plate on the underside and it should work. That was an oversight I forgot to correct
_ _
Some support pieces in the stand don’t fit
MINJAK // Jakob
I have specs for Jin without the stand. He is roughly 91cm long (36inches) Weighs about 1.5Kg (3.5 pounds)
Drealix Appleby
Is there a vague/rough measurement for the entire thing?
Dani
ive been waiting jin dahaad so sick im excited to build this
