Kekreations 3D
patreon
Flexi Leopard/Panther + Baby Keychain EARLY ACCESS
🕑 Added 2024-03-30 18:00:15 +0000 UTCHey everyone!
I'm suuuuper excited about this month's community suggestions winner release! The flexi leopard, along with baby leopard of course! I'm sooooo happy with how these guys turned out, I love them! As you can see, I gave the leg joints on the adult a total re-design! This gives them more fluid movement, easier possibility, a more sleek look (in my opinion) AND easier printability since the shoulder and hip sections wrap around the outside of the leg joints, helping give a lot better support to keep the head from wiggling and losing adhesion as it prints up.
I will most likely be going back in slowly over older flexi models to add these new leg joints as well to cut down on print failures for y'all :).
And of course we got the baby leopard as well, same as the other babies! <3 Options with and without keychain holes in the tail.
Bambu multicolor 3MF files included.
Print recs:
2-3 walls
10-15% infill
Add a brim if you have adhesion issues
Both adult and baby tested down to 65% size fine
The feet on the adult somewhat 'lock' into place when tilting them to stand and sit and such, so it's expected for them to be tighter at those angles.
Model link: https://www.kekreationsart.com/patreonmod
Refer to the pinned Patreon post here for the site password! (Once you use it once your device should remember it for next time) https://www.patreon.com/posts/3d-model-access-82725512
I hope y'all love them!
Thanks so much for all your support <3
- Kek
Comments
Kirsten McKenzie
On the Bambu 3MF for multicolor that transparent ring is a negative body so when you slice it, you'll see that it left that hole out! That way the version with and without the holes don't need to be painted twice :).
Kirsten McKenzie
Thank you so much! I'm so glad you like them <3
Dedra Coop
Wow amazing job!!!
Angelica Guida
I'm new to 3d printing, but I'm wanting to print the keychain, and I see a transparent ring on the tail in the slicer. It doesn't look like its created the hole in the tail for the keychain though. Do I need to cut that myself? or will it print properly in Bambu? This is for the multicolor keychain file.
