Kekreations 3D
patreon
Baby Flexi Critter Set 1 (Skunk, Otter, Ferret) EARLY ACCESS
🕑 Added 2024-03-18 19:10:05 +0000 UTCHey everyone!
New baby flexi set today! I've slowly been adding to my little critter sets over the past few months and it's finally time to release the first three! (Yes, that means I have more sets coming soon lol) I loveeeee how these little babies came out! The skunk and ferret definitely tie for my favorite I think, but the otter is so cute and fun too <3
Bambu multicolor 3MF files included, as well as keychain and non-keychain versions (keychain loop in the tails)
Print recs:
2-3 walls
10-15% infill
Size up and down as desired, tested down to 65% (photographs show 100% and 70%)
Add brim if you have adhesion issues
No supports
Model link: https://www.kekreationsart.com/patreonmod
Refer to the pinned Patreon post here for the site password! (Once you use it once your device should remember it for next time) https://www.patreon.com/posts/3d-model-access-82725512
I hope y'all like them!
Thanks so much for all your support <3
- Kek
Comments
Kirsten McKenzie
Cura doesn't have multicolor printing I believe so the 3MF may not work. You'll be able to open the individual STL files just fine! :)
Alice sewNsew
I donβt know why but I canβt use the file in cura? Probably something Iβm doing π³π
Kirsten McKenzie
Aww thanks so much!! So glad you like em <3
Heather Miller
Awwww! So adorable! Love them! I'm so excited to see what else you've got up your sleeves! πππ
