Kekreations 3D
patreon
Baby Flexi Bunny Keychains EARLY ACCESS
🕑 Added 2024-02-27 21:18:57 +0000 UTCHey everyone!
Little baby bunnies in time for the beginning of Spring and Easter! I pushed these guys up a bit earlier than planned because the beta testers were so quick in testing and clearing these guys and I noticed Easter was coming up so soon this year lol. I'm SO happy with how they turned out, they make me so happy!
There's a pointy eared version and floppy eared version, each one has an option with and without a keychain hole in the tail. All variations included in the Bambu 3MF multicolor file with 3 different coat pattern options.
Print recs:
2-3 walls
5-15% infill
No supports
Add brim if needed (especially on the one with floppy ears)
Tested down to 60%
Model link: https://www.kekreationsart.com/patreonmod
Refer to the pinned Patreon post here for the site password! (Once you use it once your device should remember it for next time) https://www.patreon.com/posts/3d-model-access-82725512
I hope y'all love these babies!
Thanks so much for all your support <3
- Kek
Comments
Kirsten McKenzie
Thanks so much!! And yessss definitely adding little things as we go! I know a lot of people have been putting the bunnies in the dragon egg around Easter, too!
Kyle Weiss
I absolutely LOVE these! Maybe a suggestion to go with the set you have for the dogs/cats with adoption house.. add like small things! Carrots (for bunnies)..bowls etc. It would be such an adorable set! & maybe a generic adoption house for both bunnies +dogs?
Kirsten McKenzie
What print bed and brim settings are you using? :) The ears on all of them are mirrored over each side so they're exactly the same.
Heather Rothwell
I need some help. The floppy eared bunnies are just now coming out. I'm not sure how to upload a photo to show it, but the left ear just won't print right. It breaks off on the flop eared bunnies and the long eared dogs. The right one prints just fine, but no matter how I turn it or what I do the left one breaks off. Thoughts?
