Kekreations 3D
patreon
Flexi Chameleon EARLY ACCESS
🕑 Added 2023-07-27 20:57:14 +0000 UTCHey everyone,
Time for this month's Community Suggestions Vote winner! The flexi chameleon :) This guy was SO fun to work on and I ended up enjoying him a lot more than I expected. And thanks to suggestions from testers, his toes even have subtle little grips inside so he can really hang onto things!
Print recommendations:
* 2-4 walls
* 10-20% infill
* Add a brim if you have adhesion issues
* 100% size he's a BIG boy, he's been successfully tested down to 50% to give y'all lots of wiggle room to play with! (Smaller sizes are more likely to need a brim)
Find the file in the Google Drive linked for Patrons here https://www.patreon.com/posts/3d-model-access-82725512 You'll find the file in the "Flexi" folder, then "Chameleon Toes 4" file.
If you don't see new files in the Drive, try refreshing it a few times as sometimes it takes a minute for the new files to show up :).
Hope y'all love this guy!
The Community Suggestions poll for this month will be up in a couple of days! ALSO I'm starting my move across the country on the 31st, so I may be a bit slower to respond to messages and such if you need me, but I will get to them at some point every day while traveling! The first model of August may also be pushed to the 3rd or 4th of the month, but I might be able to upload it earlier as well! Just wanted to give y'all a heads up.
Thanks so much for all your support as always! <3
- Kek
