Kekreations 3D
patreon
Dragon Shield Hair Pin EARLY ACCESS
🕑 Added 2023-07-07 00:31:59 +0000 UTCHi everyone,
It's about time for a new accessory item for y'all! This time it's a hair pin! Crossed swords with a dragon head crest on the shield ^.^
If y'all are interested in more hair pin designs, let me know, they're a lot of fun!
Print recommendations:
* 2-3 walls
* 10-20% infill
* Add brim if needed but should be fine without
* Supports optional under the shield. Most testers had it bridge over perfectly fine but you may prefer to add supports.
* Can be sized up or down to accommodate the amount/thickness of hair it's holding.
Hope y'all like this one!
Find the file in the Google Drive linked for Patrons here https://www.patreon.com/posts/3d-model-access-82725512 You'll find the file in the "Jewelry" folder, then they'll be files "Shield hair pin" and "Sword pin"
If you don't see new files in the Drive, try refreshing it a few times as sometimes it takes a minute for the new files to show up :).
Thanks so much for your support as always! <3
- Kek
