Kekreations 3D
patreon
Dog and Cat Bookends EARLY ACCESS
🕑 Added 2023-05-31 10:28:45 +0000 UTCAlright guys, last model set release of May and the winner of y'all's Community Suggestion vote last month! The dog and cat bookend sets :) These two cuties can be paired together or with their mirrored counter part instead, if you prefer JUST cats or dogs ^.^
Same as the dragon bookend set, these come with 2 versions per angle.
1 with the thin lip on the edge of the bookend which helps ensure the bookend stays in place for heavier he books.
1 without the lip if you want a décor piece or for books you're less worried about being heavy (this version also holds books up quite well, but it's important that the bookend stays up close against the books, vs letting the books fall sideways on top of the bookend).
These bookends are a tad shorter than the dragon bookends, because I wanted to make sure that even with the added lip length, they would fit on most build plates (meaning smaller than 220mm long). That puts them both at about 6.5 inches tall. But feel free to size up or down for your preference!
Print Instructions:
* 2-3 walls
* 15-20% infill
* NO supports needed on most machines
I hope y'all like these cuties!
Find the file in the Google Drive linked for Patrons here https://www.patreon.com/posts/3d-model-access-82725512 You'll find it in the "Decor" folder, under "Cat Bookend" 1 & 2, "Cat bookend lip" 1 & 2, "Dog bookend" 1 & 2, and "Dog bookend lip" 1 & 2 (8 files total)
Thanks always for your support! <3
- Kek
