Zip Tie Tuning
patreon
Golf Sound System Pt. 2
🕑 Added 2026-02-10 21:46:10 +0000 UTC
Comments
Shaun Walford
What flavor popsicles did you eat? π
Zip Tie Tuning
Its just too difficult for the shapes and aiming everything. To get it correct you'd probably need to 3D scan the whole front of the car with the A-Pillars on and off (the speakers are actually a fair bit inside of the A-Pillar, so can't just get the outside geometry). Or just a whole bunch of trial and error. Would be worth it if you wanted to build 10, but for just a one off only 3D printing the speaker mounts and popsicle sticks is much easier.
Andrew Pedersen
Was wondering why you guys didnβt use the 3D printer for this bit as well?
