my3dprintforge
patreon
March release testing
🕑 Added 2021-02-26 17:04:59 +0000 UTCHello! I wanted to show you the pictures of printing build-plates from the next month's release.
I placed them as close together as possible.
So far I have printed and tested four plates and there are three to go! :)
Made couple of changes to the models because some areas were too thin for 32mm versions and fixed some supports - that's why I test all my models before releasing them.
If all goes according to plan you will get your download link on March 3rd!
P.S. All models will have Chitubox files in case you need to make some adjustments.
Comments
Hehe π Just drag and drop full plate of pre-supported models. Then try to place them as close as possible (rotate, move and so on). Takes a bit of practice. π
Teach me your ways Chitubox Master. How did you do that to get everyone on there!
