mrbaddeley
patreon
Optional Charge Port - Fixed and Retro parts available
🕑 Added 2018-01-07 08:28:42 +0000 UTC OK, firstly apologies, I released the Charge port a little too early before I'd fully printed all the parts. Big thanks to Wayne for pointing it out, basically there's a magnet holder in the recess to hold the charge door shut however I didn't allow for the door and the magnet holder was flush with the "inner skin". This meant the door wouldn't close as it hit the magnet holder. Rather stupid of me!! I've now fixed the model and uploaded the files. (show in the pic above). I've also added two "retro fit" options to fix it. (in "Modifications" folder. The fixed files obviously don't need these, these are only for where the first version has been printed. (Two options detailed below).1) A standalone Magnet Holder, where if you've printed and fitted the main body parts, you can dremel or cut the magnet holder (in the main body, just inside the recess) out to allow the door to close, tidy up and glue in the standalone Magnet Holder about 4mm back.
2) A door with a recess, this allows the model to stay "as is" and has a recess in the door for the magnet holder. The challenge is finding a thin piece of steel (1mm x 6mm or thinner) to fit in the door, but it would work I think.
Apologies, and happy printing!
Mike,
Comments
Michael Baddeley
Hi, yes these replace the existing parts in Ring 2 if you want an opening charge port. this can just be a ‘feature’ or a practical place for charging depending on the electronics you choose, there’s quite a few options for batteries and charging cables so you can port the cables / connectors through this panel. There’s loads of solutions and builds documented in the builders club for this charging approach.
hi just a little question ! i have printed all 3 ring but not glued them together yet , so if i want i could print these 2 and replace the one with no door that i have already printed? and is this charging door to charge the battery instead of going from the back?(sorry i know this question may sound stupid but im not that far in the build yet to know everything about the electronics and all)
