mrbaddeley
patreon
Basic Dome ready for test printing
🕑 Added 2017-10-11 07:11:57 +0000 UTC I've done the first cut on the R6 dome. The lower and upper ring is simply the same part printed 6 times and fits together with a dovetail (again slight sanding may be needed depending on the tolerance of your printer). For the main dome I've cut into 9 parts with hole and peg fitting (as shown in the transparent part above). I have not done any test prints on the R6 Dome yet, but the STL files are available in the early bird Patreon page in the WIP folder. This design fits the standard Lazy Susan so should be a fairly easy swap on the R2 body. I will upload the top of the dome and panels once I've completed them. Happy Printing,Mike,
Comments
Michael Baddeley
:-) yeah I’ve done that a few times.
Thanks michael can't wait to finish the fantastic projects staying up till 1.30 in the morning then up for work at 7work
