mrbaddeley
patreon
3 leg jabba tray complete.
🕑 Added 2018-02-04 11:09:49 +0000 UTC 3 leg Jabba tray printed, tested and I’m happy with the fit. Pics are unfinished raw PLA bronze filament, incorporates magnets on all trays for accessories which won’t come off when moving. Uses M4 bolts and square nuts throughout. Tray is solid and holds weight with enough flex to prevent damage. Files and instructions for both 2 leg and 3 leg available In the early bird Patreon share. Instructions for 2 leg and 3 leg coming (although instructions are virtually identical. ). Files shared via public folder in a couple of weeks as always.
Comments
Phillip Williams
OK Thanks, I am starting to print this tomorrow.
Michael Baddeley
Also bolt lengths are different for 3 legs, I need to complete the instructions.
Michael Baddeley
The leg build is the same for left and right. 1a is the main frame and 2a is the face on the other side of the leg. It screws / glues in. They’re cut differently for strength, I don’t put cut points in the same place.
Michael Baddeley
Sorry!! Will fix that, apologies.
Phillip Williams
I read the Instructions which get a A+ as you have listed parts but I didn't get a mention in the Supported section :
Phillip Williams
Under the wip 3leg leg-3legs , whats the difference between leg1a and leg2a , are they left and right and if so why are they cut differently , thanks again.
Michael Baddeley
I think around 2 reels, maybe into a third. Really difficult for me to judge as I have loads of reprints while I get the design right and I printed the 2 and 3 leg version.
Phillip Williams
How much filament did you use to make the tray?
Geoffro / Hex3D
so much goodness in one photo
Orpheus1103
Awesome !!!
