mrbaddeley
patreon
Drive gear printed and tested.
🕑 Added 2017-07-10 21:22:19 +0000 UTC Drive gear, drive motor bracket, slip ring bracket and cabling support all done and tested. I've just got some soldering to do now! Note these designs are not posted at the moment because my phone lines and internet is down. I'll pop them up as soon as I can! Damn BT...
Comments
Uau! It's a big one.. mine it's only 35mm diameter.. I'll have to adapt somehow I think...
Michael Baddeley
The link is <a href="http://www.maplin.co.uk/p/mfa-45-15v-large-501-single-ratio-motor-gearbox-n99bn" rel="nofollow noopener" target="_blank">http://www.maplin.co.uk/p/mfa-45-15v-large-501-single-ratio-motor-gearbox-n99bn</a>
Mike.. what's the size of the motor you're using??
Michael Baddeley
It is indeed. The files are from the bb8 builders club. They are superb.
Is that BB8 I seen the backgorund? 3d Printed? What model did you use for that?
upsss.thanks!! printing right now... thaks!
Michael Baddeley
Hi, new folder in Patreon share called DomeDrive. They're in there.
hi!! cant find the files.. WIP /gear is empty... thanks!!
Michael Baddeley
It is a 6 wire set up, the hole in the centre though can be adjusted easily and it's a single piece which has the hole in as part of the structure so send across any sizes and I'll change accordingly. Takes seconds.
Illuminati Games
Awesome
LarryJ
What size (diameter) slip ring is this designed for? I'm only able to count 5 wires, but I'm guessing this is a 6 wire setup?
