mrbaddeley patreon

Final post of the evening.

🕑 Added 2017-09-03 20:54:02 +0000 UTC

Comments

Michael Baddeley

Hi, I don't have a full BOM list, there's recommendations in the instructions on a module by module basis. M4 bolts, nuts and square nuts are my standard fitting however I bought a couple of boxes of various bolts and small self tapping screws. 6mm and 8mm threaded rods are used or the foot drives along with 6mm and 8mm bearings. I know people are using different fixings as the design can be fixed in many different ways and metric / imperial differ by country.

Hi, do you have a BOM with all screws, bolts, etc used on your project?

Michael Baddeley

Should work, just need to remap the keys.

The Coined Box

i am planning to use the SHADOW drive system with 2 PS3 move controllers if i remap the sounds would i be able to make it do what yours does?

Todd Walden

Wonderful. Thank you.

Michael Baddeley

Simplify3d

Todd Walden

Just out of curiosity, what slicer do you use?

Geoffro / Hex3D

looking very neat!

Michael Baddeley

<a href="https://www.thingiverse.com/thing:2211836" rel="nofollow noopener" target="_blank">https://www.thingiverse.com/thing:2211836</a>

Michael Baddeley

I did do a cut down version on Thingiverse which should fit a standard CSR build (no integrated skins). Not tested it personally as I have only built fully printed ones.

I need to see if I can fit your utility arms in my styrene build.