mrbaddeley patreon

Modified Centre Foot files this morning.

🕑 Added 2017-04-15 08:53:19 +0000 UTC

Comments

Michael Baddeley

Cool, I have a plan with 6mm bearing wheels and a ball bearing.

"6mm" ! Those I can get it here!!.. :)

Here... <a href="https://www.dropbox.com/s/6z9cqio1wm5vhvu/IDeaForWheelRING.123dx?dl=0" rel="nofollow noopener" target="_blank">https://www.dropbox.com/s/6z9cqio1wm5vhvu/IDeaForWheelRING.123dx?dl=0</a>

I did a very poor draft of the Idea... <a href="https://www.dropbox.com/s/6z9cqio1wm5vhvu/IDeaForWheelRING.123dx?dl=0" rel="nofollow noopener" target="_blank">https://www.dropbox.com/s/6z9cqio1wm5vhvu/IDeaForWheelRING.123dx?dl=0</a>

Michael Baddeley

Ok, leave it with me :-) can you get standard 6mm bearings or 8mm bearings?

Great! just cant wait to see that, because down here in Brazil is impossible to find one of that Lazy Susan that builders uses! So, to print that is the perfect solution.. By the way, have think about do not use a "lazy Susan solution"and try a system with some other layout.. like a "ring with inner wheels"instead of ball bearings ?..

Michael Baddeley

I've just ordered an 18 inch lazy Susan to test how we can fit the dome. The upper ring on the body does have holes for a lazy susan. The printed lazy susan is too noisy and not smooth hence using a metal one. The only challenge is the lower ring on the dome and how that fits to the lazy Susan. I have seen the lazy Susan fit directly into the body without the ring so that also may be an option so that's why I want to look at. Again intend to redesign the inner gear and drive etc.

By the way.. how We fit the Dome on the body.. I mean, shall I use that lazy susan from the version one, or there will be an specific design for that ?

Great!!

Michael Baddeley

Hi, it's an updated design. Same size as other one and as accurate but I've redesigned the fixings and the internals. I will do the same for the outer feet.

Nice..!! so, this is only the Center foot or all the feet ? and are different files from the "Center leg Lift" folder, right ?

Thank you Michael... and thanks for the work you have done. I applaud you for sharing your work with the community. It's good to see these days... cheers