ForgeCore
patreon
Wall Mounted Controller Holder
🕑 Added 2023-12-31 22:04:57 +0000 UTCUPDATED: Added a low profile Wall Mounted Controller Holder and a Wall Mounted Controller Holder with built in supports. Make sure to use gyroid infill for this one.
This Wall Mounted Controller Holder is print in place. Screw the rails into the wall and slide the holder overtop of it! Perfect for saving space on your desk and displaying your controllers.
For those of you that want to know what I printed this with: I used Materhackers Pink Blue Silky PLA
After you print it, the hinges should swing freely, and you'll need to break the smaller hinges free with some pressure. You may notice some stringing inside the smaller hinges, which can be removed with some snips.
There are 2 rail types. The Base Rail has a stopper to hold up all the controller holders, so use just one of those as the bottom rail
Comments
ForgeCore Co
15% gyroid
Hi! How much infill is recommended to use?
ForgeCore Co
Thats for you to decide based off of your local market, shipping costs, and how you decide to split up multiple pieces. At least 10-20x your material cost
Hello What should be the price of this product?
ForgeCore Co
Infill of 15% is what I used. I will also be uploading a version with a pre-designed support this evening
ForgeCore Co
Hi Jennifer! I need to look at Cura slicer I forget if it has support painting. But I’m actually working on a version right now that has the supports already designed into it, if you can wait until this evening for me to upload that?
I need more details on adding the tree supports and other printer settings. I am using Cura Slicer and when I added the supports it added them all around the hinges for the pull out controller shelf. When I tried to remove them the larger hinge snapped and the part is useless now. Before I attempt to reprint, I would like more details on the support settings as I have not used them before.
Any advice on infill density? I'd also like a few tree support tips... I'm using Creality Print but new to the whole thang. Thanks!
